I have the problem with correct connection and working NEO box (LED strips) and OLED LG C1 where there are 4 HDMI IN (inputs) but all of them have 4K 120 Hz.
May be the problem is that LG has HDMI IN (all 4 intputs) with 4K 120Hz (instead of 60 Hz)?
According to the specification inputs have 2.1 version.
I tried to connect NEO with all HDMI inputs but the problem's result is the same - strips do not work when I choose Screen in the APP
Sorry for my English in video . It was usual picture on TV (even not HD)
Is it correct strip's working in Music Spectrum mode ?
Then I tried to watch video 4K from Youtube
and 4K film from USB
and the problem's result was the same - LED strips did not work
Looking at the video, where is the input connection of the box? I see only the output of the neo box connectet to the tv. You have to give the box a input signal.
For example firetv 4k -> Input Neo box and output neo box to TV.
I use the follwoing setup:
firetv 4k, Sat-Receiver and Xbox all connected to a pioner receiver, the output of the pioneer receiver is connected to the input of the neobox and the output of the neobox is connected to the tv.
I have a LG B2 and with me there is the problem that the Lytmi box can not process my Dolby Vision signal, the light works but is distorted (shows only purple and red). I use a splitter from Feintech there is my Apple TV connected, the splitter splits the HDMI signal to the Lytmi Neo Box and to the TV, because Lytmi does not support eArc. Is there a solution to get a Dolby Vision picture on the TV with working Ambilight?
These films (1 in BluRay format, 2 in mp4 and all - with DV) were on USB memory card.
I mentioned above (see page 1) that when I see the films from Dune (which was connected with TV directrly) then there is DV
But if I see the film drom Dune through Lytmi then there is NO DV
Thus the splitter solved the problem
But there is some small difference in DV signal
It is directly signal - STD after DV
it is after Lytmi box and splitter - LLDV
I do not know about this difference
(and it was without splitter but with Lytmi)
And above were info from DUNE
Below is the info from TV LGC1
what kind of signal does the tv get? that only shows what is being played.
Hi... here is my short report about DV
I have received the promissed splitter and tried it on
Now the cables is too long and I will change them for shorts
I tried 3 films and DV works with splitter !
in this case You have to use some external TV box where will be install APPs
How do I address the apps on the TV itself such as Youtube Netflix etc? Because this solution is only for the cable connection.
may be You have to find some splitter where INPUT will be for these cables and HDMI OUT for connection with Lytmi box
Via cable the local channels and via Internet (Wlan from the TV) Youtube, Netflix etc...
how do You watch TV ? By cable or internet ?