I cleaned the back of the tv real well. A week later kaaaplop…the light strip fell down the top and sides fell off. The corner brackets aren’t strong enough. I had to buy more 3m tape but notice the lights sag as well. They are too heavy. I need more mounting brackets !! Can I get more middle brackets? They will keep sagging and pop off again. Grrrrrr.
top of page
bottom of page
Had the exact same issue with my setup on my 75" Sony, clean the area where the holder is to be placed with IPA and then use some low temperature hot glue to affix the holder, you may need to do this for every light strip holder, I did mine a few months ago and have not had any issues since. Good luck.
Hey Scott
I have a solution for your problem with your RGB lights strips falling off the back of your TV set, heavy duty Velcro strips. I place Velcro strips on the four corners pieces instead of using the glue strips that come with the kit I instead used four strips of Velcro strips to hold in place the corner pieces and i then carefully trim down the size of the Velcro strips that I was going to uses to hold the two RGB led lights strips on the back of the tv and very careful line up both Velcro strips so that they match up perfectly when I placed both RGB strips on the back of the tv. I found that three Velcro strips for the top and bottom of the tv to hold the RGB strips and two Velcro pieces for the side area. problem solve! Let me know if this solution works for you Thanks.
3M double sided tape is your friend... You can pick up a roll at a big box store, or amazon.
Same issue here. Even with the gorilla glue mounting tape, they keep falling off!!!
sorry about this, currently, maybe you can search cable bracket on Amazon, and you will find a suitable one. https://www.amazon.com/s?k=cable+bracket&crid=1B5OKTVJDLHK4&sprefix=cable+brac%2Caps%2C411&ref=nb_sb_noss